Declipper repairs digital and analog clipping artifacts that result when A/D converters are pushed too hard or magnetic tape is over-saturated.
Single-band Mode: enables single-band declipping
Quality - controls the interpolation processing quality.
Clipping threshold (dB FS) - selects the clipping level used for detection of clipped intervals. User should set it to be just below the actual level of clipping.
Makeup gain (dB) - selects the gain to be applied to the selection after declipping.
Histogram - a graphical display of waveform levels for the current selection
Declipping usually increases signal levels by interpolating signal segments
"above" clipping point, but the absence of makeup gain can make the signal clip
again if the waveform format offers no headroom above 0 dB FS. If the
floating-point waveform format is used, the restored intervals can be safely
stored even without makeup gain (but they will appear as clipped during
playback).
Multi-band Mode: enables multiband declipping
Number of Bands - adjusts the number of bands used for multiband declipping from 8 up to 128.
Multi-resolution Mode: enables multiresolution processing to
interpolate clipped intervals. (advanced mode only)